User manual

Mobile Computer MC 95xx
ex
-NI
Type B7-A29.-…………
Operation
Technical data subject to change without notice.
Issue: Revision 1 / March 2011
Page 21 of 57
Caution!
Follow proper ESD precautions to avoid damaging the micro SD card. Proper
precautions include, but are not limited to, working on an ESD mat and ensuring that the
operator is property grounded.
BARTEC recommend to use following tested micro SD cards:
− 1 GB Order no. 17-C1Z0-0007 or
− 2 GB Order no. 17-C1Z0-0008
4.4.1 Installing a Micro SD Card
To install the micro SD card:
(1) If the MC 95xx
ex
-NI is in standby mode, press the red Power button to activate the
device.
(2) Press the red Power button to suspend the MC 95xx
ex
-NI.
(3) Wait for red decode LED to turn on and then turn off.
(4) Unhook the handstrap.
(5) Remove the battery.
(6) Remove the SD card cover using the end of the stylus.
Figure 4-1: SD Card Cover Remove
(7) Slide the micro SD card holder door to the left to unlock.
(8) Lift the micro SD card holder door.
Figure 4-2: Lift micro SD Card Holder door
(9) Place the micro SD card onto the contacts.