User manual

Mobile Computer MC 95xx
ex
-NI
Type B7-A29.-…………
Operation
Technical data subject to change without notice.
Issue: Revision 1 / March 2011
Page 25 of 57
4.5.2 Removing the SIM card
Caution!
Suspend the MC 9596
ex
-NI prior to removing the battery. Failure to properly remove the
battery may cause the MC 9596
ex
-NI to cold boot and potential loss of data.
To remove an micro SIM card:
(1) If the MC 9596
ex
-NI is in suspend mode, press the red Power button to wake the
device.
(2) Press the red Power button to suspend the MC 9596
ex
-NI.
(3) Wait for red Decode LED to turn on and then turn off.
(4) Unhook the handstrap.
(5) Remove the battery.
(6) Remove the SIM card cover using the end of the stylus.
(7) Slide the SIM card holder door to the left to unlock.
(8) Lift the SIM card holder door.
(9) Remove SIM card from holder.
(10) Close the SIM card holder door.
(11) Slide the SIM card holder door to the right to lock into place.
(12) Align the SIM card cover over the access hole and press down until it snaps into
place.
(13) Replace the battery.
4.6 Battery
This chapter provides information on battery functionality, battery status indications,
charging the MC 95xx
ex
-NI charging spare batteries and power saving techniques.
Caution!
The battery may only be charged and changed outside the hazardous area!
It must be ensured that only original batteries of the following type/s are used in safety-
oriented operation. B7-A2Z0-0011 with 3.7 V/4800 mAh.
The use of imitation batteries or batteries from other manufacturers will render the type
of ignition protection ineffective and there will then be a risk of fire or explosion.
Note
The temperature range for charging the battery is 0 °C to +40 °C. Please note that
charging the MC 95xx
ex
-NI is under intelligent control.
For this purpose, the charging procedure of the MC 95xx
ex
-NI is activated and
deactivated at short time intervals to keep the battery temperature within the
permissible range. A LED on the MC 95xx
ex-
NI indicates when the charging procedure
was disabled because of excess temperature.
Use only accessories approved by BARTEC and Motorola to charge the batteries.