User manual

Mobile Computer MC 95xx
ex
-NI
Type B7-A29.-…………
Operation
Technical data subject to change without notice.
Issue: Revision 1 / March 2011
Page 27 of 57
4.6.3 Battery Status
The MC 95xx
ex
-NI battery provides status information on the front of the battery that
allows the user to make determination on what battery to use. The battery status
indications vary depending upon the mode of the battery:
- Installed in an MC 95xx
ex
-NI
- In a charger
- Stand-alone
4.6.4 Installing the Battery
Attention!
The battery may only be charged and changed outside the hazardous area!
It must be ensured that only original batteries of the following type/s are used in safety-
oriented operation. B7-A2Z0-0011 with 3.7 V/4800 mAh
The use of imitation batteries or batteries from other manufacturers will render the type
of ignition protection ineffective and there will then be a risk of fire or explosion.
To install the battery:
(1) Insert the battery, top first, into the battery compartment.
(2) Press the battery down into the battery compartment until the battery release
latches snap into place.
Figure 4-10: Inserting the Battery
(3) The MC 95xx
ex
-NI powers up automatically after inserting the battery. If the battery
has been changed previously.
4.6.5 Replacing a battery
Caution!
The battery may only be charged and changed outside the hazardous area!
It must be ensured that only original batteries of the following type/s are used in safety-
oriented operation. B7-A2Z0-0011 with 3.7 V/4800 mAh
The use of imitation batteries or batteries from other manufacturers will render the type
of ignition protection ineffective and there will then be a risk of fire or explosion.
Attention!
Suspend the MC 95xx
ex
-NI prior to removing the battery. Failure to properly remove the
battery may cause the MC 95xx
ex
-NI to cold boot and potential loss of data.