User manual

Mobile Computer MC 95xx
ex
-NI
Type B7-A29.-…………
Operation
Technical data subject to change without notice.
Issue: Revision 1 / March 2011
Page 29 of 57
(6) Lift the battery from the MC 95xx
ex
-NI.
(7) Insert the replacement battery, top first, into the battery compartment in the back of
the MC 95xx
ex
-NI.
(8) Press the battery down until the battery release latches snap into place.
The MC 95xx
ex
-NI powers up after inserting the battery.
4.6.6 Powering On the MC 95xx
ex
-NI
After the MC 95xx
ex
-NI is connected to power the splash screen displays for about a
minute as the MC 95xx
ex
-NI initializes its flash file system, then the calibration window
appears.
Note
The Calibration screen can be accessed by pressing CTRL key - BKSP key or tapping
Start > Settings > Screen > Align Screen button.
Calibrating the Screen
To calibrate the screen so the cursor on the touch screen aligns with the tip of the stylus:
(1) Remove the stylus from its holder on the side of the MC 95xx
ex
-NI.
(2) Carefully press and briefly hold the tip of stylus on the center of each target that
appears on the screen.
(3) Repeat as the target moves around the screen, then tap the screen to continue.
4.6.7 Charging the battery
Attention!
The battery may only be charged and changed outside the hazardous area!
Note
The temperature range for charging the battery is 0 °C to +40 °C. Please note that
charging the MC 95xx
ex
-NI is under intelligent control.
For this purpose, the charging procedure of the MC 95xx
ex
-NI is activated and
deactivated at short time intervals to keep the battery temperature within the
permissible range. A LED on the MC 95xx
ex
-NI indicates when the charging procedure
was disabled because of excess temperature.
Use only accessories approved by BARTEC and Motorola to charge the batteries.
Before using the MC 95xx
ex
-NI for the first time, charge the battery using either a charging
cable or a cradle:
− USB Charging cable
− Charging Cable (only charging)
− Single USB Charging Station
− 4-Slot Charging Station (only charging)
− 4-Slot Ethernet Charging Station