User manual

Maintenance, Inspection,
Repair
Mobile Computer MC 95xx
ex
-NI
Type B7-A29.-…………
Page 46 of 57
Technical data subject to change without notice.
Issue: Revision 1 / March 2011
8. Maintenance, Inspection, Repair
This chapter describes cleaning and storing the MC 95xx
ex
-NI, as well as possible
procedures when problems occur while using the MC 95xx
ex
-NI.
Caution!
When doing maintenance or servicing or when checking associated equipment, comply
with the applicable regulations in accordance with directives IEC 60079-19 and IEC
60079-17!
Installation/dismantling, operating and maintenance work may be carried out by trained
specialists only. Statutory regulations and other binding directives on workplace safety,
accident prevention and environmental protection must be adhered to.
You should heed the following tips when using the MC 95xx
ex
-NI to guarantee fault-free
operation:
− Pay attention that the MC 95xx
ex
-NI display is not scratched. When working with the
MC 95xx
ex
-NI use the supplied input pen or pens with plastic tip which are designed
for use with touch screens. Never use a ballpoint pen, pencils or other pointed items
on the MC 95xx
ex
-NI screen. BARTEC recommends using a screen protector, Part
no. B7-A2Z0-0017.
− The MC 95xx
ex
-NI touch screen is made of polycarbonate. Please make sure that the
MC 95xx
ex
-NI is not dropped or subjected to hard knocks.
− Protect the MC 95xx
ex
-NI against extreme temperatures. Do not leave it on the
dashboard of the car on hot days and keep it away from heat sources.
− Do not store the MC 95xx
ex
-NI in dusty, moist or wet environments.
− Use a soft spectacle cleaning cloth to clean the MC 95xx
ex
-NI. If the MC 95xx
ex
-NI
display surface is dirty, clean it with a soft spectacle cleaning cloth soaked in diluted
window cleaner.
− Change the re-chargeable battery regularly to ensure maximum battery life and
equipment performance. Battery life depends on the individual usage pattern. The
battery provides a state display to estimate the remaining life. You can find further
information in chapter 4.6 "Battery".
− Pay attention that the scan window is not scratched. Clean the window regularly.
Dust, contaminants and scratches on the scan window can lead to visible spots on
the pictures taken with the scanner.
− The battery should be completely charged before it is used for the first time. Note that
the maximum capacity of the battery is not attained until after approx. 5-6 charging
and discharging cycles.