User manual

Maintenance, Inspection,
Repair
Mobile Computer MC 95xx
ex
-NI
Type B7-A29.-…………
Page 50 of 57
Technical data subject to change without notice.
Issue: Revision 1 / March 2011
Attention!
Do not direct the nozzle onto yourself or other persons. Pay attention that the nozzle
does not point towards your face.
(6) Make sure that no lint remains from the cotton buds and remove any lint.
(7) If there are any grease and dirt deposits on other sectors of the charging station,
remove this with a lint-free cloth and alcohol.
(8) Allow the alcohol to dry at least 10 to 30 minutes in the air (depending on the
ambient temperature and humidity) before you connect the charging station to the
power source. The required drying time increases with lower temperature and high
humidity. The required drying time decreases with higher temperature and lower
humidity.
8.3.8 Cleaning interval
The customer must determine the cleaning interval at his own discretion and with
consideration of the different environments in which the mobile units are used. The
devices can be cleaned at discretionary frequent intervals. When used in very polluted
environments it is, however, advisable to clean the scan window regularly to guarantee
optimum scan performance.
8.4 Information about Repairs
Customer Service Information
If you have problems with your device, please contact the BARTEC sales company or
commercial representation responsible for your region. You can find contact information
under:
http://www.bartec.de/homepage/eng/10_unternehmen/10_unternehmen/s_10_10_50.asp?C=1
Please have the following information available when you contact BARTEC:
− Serial number of the device (you can find this on the manufacturer label)
− Model number or product name (you can find these on the manufacturer label)
− Software type and version number
Manufacturer label