Instruction manual

RazorGage End-User Manual
Technical Services, Inc Page 9
The Auto Pusher Screen allows you to define cut routines for specific board
lengths and save them to the hard drive. The number of routines one can
save is virtually unlimited. See the steps below for defining a cut routine:
1
2
3
4
5 6
7
8 9
Press
Punch in overall length of stock
Punch in the desired position you wish the stop to go for loading the stock
Punch in the leading edge trim amount
Enter the length of the first part you want to cut
Enter the quantity of parts of that length. Press
Repeat steps 5 & 6 until done and press
Once a board is saved, press and the pusher will retract to the load position
defined in the routine
When the pusher is in load position, place a board against the fence and against
the pusher and press . The routine will run its pattern. If you check Auto Run
and have the appropriate options, your RazorGage will cycle clamps, saw, and
advance automatically.