Instruction manual

Sawblade Lubrication System:
The Sawblade Lubrication System is used when cutting aluminum or other non-ferrous materials. This system
normally uses a Water Soluble Oil mixture of 10 parts water to one part oil. The system operates by siphoning
the lubrication up the line to the spray nozzle. Any air leak will cause inconsistent fluid flow to the spray nozzle.
BE SURE your fluid is free from chips and other debris. A fluid container supplied with the machine contains
a One-Way Check Valve, Part No. B3P96 at the end of the clear fluid line. This check valve helps to hold the
lubrication in the line. However, after a couple of minutes, the lubrication or oil will back-flow into the container.
Priming of the system may be necessary if the machine has been standing without use. The system may be shut
off by closing the toggle valve next to the vacuum pump. The fluid must be clean or the Vacuum Pump will clog.
CTD Bio Lubrication System:
The CTD biodegradable lubrication system operates by pulse spraying a minute amount of biodegradable
lubricant directly on to the saw tooth of the blade in time-measured increments. The majority of the lubricant
then dissipates with the heat of the cutting action. Chips coming off the blade are hot and dry, and are more
easily collected. (See specific instructions included with system.)
-9-
Part No. Description
B3P195 Vacuum Pump
B3P196 Link Tubing
B3P197 Nozzle Fitting
B3P198 1/8” NPT Adapter
B3P199 1/4” Elbow
B3P61 Shut Off Toggle Valve
B3P100 1/8” NPT to 1/4” tube fitting
B3P96 Check Valve
B3P97 Lubricant Container
BF30 Bracket for SLS
P-
P+
Vacuum Lubrication Pump
Part No. B3P195
CTD MACHINES, INC.
LOS ANGELES, CA USA
(P+)+(P-)
B3P61
B3P100
B3P199
B3P198
B3P197
B3P196
B3P195