Specifications

2-17
2
Changing a Unit in the Unit Bay
The Unit bay on the right side of your computer can be installed with a CD-RW
drive, a floppy disk drive or an optional secondary battery. Your computer supports
hot-swap, so you can change units without turning off your computer.
Change the units in the bay by following the steps below.
1. Remove any floppy disks or CDs from the drive if currently installed in the unit
bay.
2. Click
icon on the taskbar; then
Change device in Swappable Bay (xxxxx)
.
3. Read the message in
BaySwap
window carefully (Do not click
OK
).
4. Close the upper cover of the computer; then turn it over and locate the unit bay
lock latch.
5. Slide the latch towards the rear edge of the computer and hold.
Drive lock latch
Raised ribs to push
unit out of the bay
CD-RW drive
6. Slide the unit out by pushing on the raised ribs on the bottom of the unit. You
can release the lock latch once the unit is partly removed from the unit bay. Pull
the unit all the way out of the unit bay.
7. Position the replacement unit correctly and insert it into the unit bay. Push it all
the way in so that you feel the connector on the rear edge of the unit engage with
the connector inside the bay. Verify that the drive lock latch is in the locked
position.
8. Turn your computer over and open the upper cover.
9. Click OK in
BaySwap
window. Your computer automatically registers and
configures the new unit.