Specifications

7-3
7
4. To change the password, type the new password again and press
Enter
. To
delete the password, just press
Enter
again.
5. When the confirmation message appears, press
Enter
.
6. Press
Esc
and select
Exit Saving Changes
.
7. Press
Enter
twice. The system restarts.
Password Requirements
If you have enabled
Password on boot
in the
Security
page of the setup utility, the
system will ask for a password when the system is started. If a user password is
entered, then the user has limited access to the floppy disk drive as set by the holder
of the supervisor password.
When the setup utility is opened, a password is required. If a user password is
entered, the user does not get access to some items shown in
Supervisor Password
and User Password
on the previous page.
Setting a Password for Standby/Hibernate Resume
Use the Windows
Power Options Properties
program to set a password that must be
entered in order to resume the system from a standby/hibernate mode. If you have
already installed a Windows password you can skip steps 1-4.
1. From the
Start
menu, select
Settings
-
Control Panel
.
2. Click
view all Control Panel options
.
3. Double-click
Passwords
to open
Passwords Properties
dialog box.
4. Use the
Change Passwords
tab to install a password for windows.
5. Restart your computer to complete the password installation.
6. Return to the
Control Panel
. Double-click the
Power Options
to open the
Power
Options Properties
dialog box.
7. Click
Advanced
tab, and check
Prompt for password when computer goes off
standby and hibernate
.
8. Click
Apply
and
OK
.