Installation manual

6 W100T Twin Alternating Series Softeners
W100T System Programming
W100T Quick Programming Guide
A quick programming guide has been listed below for convenience specifically for the W100T series water softening systems. For other
programming requirements not listed in the Quick Programming Guide, please see the detailed programming section of this manual.
CHART 1: Configuration Settings
Press and Hold Up and Down for 5 seconds Set 2CS to 10T
Press Next Set 4CS to Volume Arrow Only
Press Next Set 5CS to on 0
Press Next Set 7CS to flash between Off and DP
CHART 2: Regeneration Cycle Times
Press and Hold Next and Down for 5 seconds Set 2CT to SoFT
Press Next Set 3CT backwash length
Press Next Set 4CT draw length
Press Next Set 5CT 2
nd
backwash length
Press Next Set 6CT rapid rinse length
Press Next Set 7CT brine tank refill length
CHART 3: Installer Display Settings
Press and Hold Next and Up for 5 seconds Set 2i to gallons between regenerations
Press Next Set 3i to preferred regeneration day override
Press Next On 0 will appear