Specifications
Using Your Notebook 3-5
3
When entering or returning from suspended mode, be sure to observe the
following precautions. Otherwise, the notebook may not operate correctly
after the notebook has resumed from the suspend mode.
•
Do not operate the keyboard, Glide Point or mouse in the process of
entering or returning from suspended mode.
•
Before activating suspended mode, terminate any optical or modem
communications and make sure that no video or audio playback is in
progress.
•
In Windows 95, set the Power Management item to Advanced.
•
When using a modem, set the Modem Power when Suspend to RAM
item to Enabled.
•
When using a PC Card, set the PCMCIA Power when Suspend to RAM
item to Enabled.
Resuming from Suspend Mode
Normally, resuming from a suspend mode is triggered as follows:
•
By the power switch.
•
If Suspend to RAM is active, by pressing any key, or by calling up the modem.
•
Also, if the suspend state was entered by closing the cover, operation resumes
when the cover is opened (as long as battery voltage is sufficient).
•
However, if the suspend state was caused by the battery capacity dropping below
a certain level, operation can be resumed only after AC power is connected or a
charged battery installed, and then only by the power switch.
When a resume event occurs, the system returns to where it was when suspend mode
was entered, e.g., software applications open, the display reappears, etc.