Specifications

Peripherals 4-9
4
Disabling the GlidePoint
When connecting a mouse to your notebook, you can disable the GlidePoint in the
following steps:
1. Make sure the mouse is enabled before disabling the GlidePoint. If the mouse is
not enabled, the cursor does not move when you move the mouse.
2. From the Start menu, select SHARP Applications - GlidePoint Control.
3. Select Disables GlidePoint.
4. Click OK.
If the Glide Point was disabled when entering suspended mode, it will be
enabled after returning from suspended mode.
Connecting a Serial Mouse
1. Turn off the notebook.
2. Locate the RS-232C serial port ( ).
3. Plug the serial mouse into the RS-232C serial port.
Figure 4-4. Connecting a Serial Mouse
4. Turn on the notebook.
5. From the Start menu, select Settings - Control Panel.
6. Double-click Mouse.
7. Click the General Tab, then click Change.
8. Select the manufacturer and model name, then click OK. Click Close.
9. Click Yes and the notebook will restart again.
When the serial mouse is active, the GlidePoint cannot be used.