Datasheet

SHARP CORPORATION
I
ED-97136 1 September 8, 1997
MODEL No.
PC357NT
PAGE
Attach
sheet- 1-2
3. Precautions for Soldering Photocouplers
(1) If solder reflow :
It is recommended that only one soldering be done at the temperature
and the time within the temperature profile as shown in the figure below.
230°C
25°C
Since, influence to the device is different according to reflow equipment
and its condition, please use the device after contlrming no damage
in the actual using condition.
(2) Other precautions
An infrared lamp used to heat up for soldering may cause a localized
temperature rise in the resin. So keep the package temperature within
that specified in Item ( 1). Also avoid immersing the resin part in the solder.