Operation Manual
Table Of Contents
- Introduction
- Easy Start
- Setup
- Connections
- Basic Operation
- Useful Features
- Operating with the Remote Control
- Menu Items
- Using the Menu Screen
- Picture Adjustment (“Picture” Menu)
- Signal Adjustment (“SIG-ADJ” Menu)
- Adjusting the Projected Image (“SCR-ADJ” Menu)
- Adjusting the Projector Function (“PRJ-ADJ1/2” Menu)
- Auto Sync (Auto Sync Adjustment)
- Auto Power Off Function
- Auto Restart Function
- Speaker Setting
- Selecting the Transmission Speed (RS-232C)
- Fan Mode Setting
- System Lock Function
- Keylock Function
- Selecting the Quick Start Menu
- COMPUTER2 Select
- Setting the FUNCTION Button Operation
- STANDBY Mode
- DLP® LinkTM
- DLP® LinkTM Invert
- Returning to the Default Settings
- Checking the Lamp Life Status
- Setting Up the Projector Network Environment (“Network” Menu)
- Appendix
46
4
Setting the Video System
The video input system mode is factory preset
to “Auto”; however, a clear picture from the
connected audio-visual equipment may not be
received, depending on the Video signal
difference.
In that case, switch the Video signal.
Selectable items
Auto
PAL
SECAM
*NTSC4.43
NTSC3.58
PAL-M
PAL-N
PAL -60
* When reproducing NTSC signals in PAL
video equipment.
The Video signal can only be set in S-VIDEO
or VIDEO mode.
When “Video System” is set to “Auto”, you
may not receive a clear picture due to signal
differences. Should this occur, switch to the
video system of the source signal.
•
•
Note
5
Setting the Video Setup
Selectable
items
Description
0 IRE Sets the black level to 0 IRE.
7.5 IRE Sets the black level to 7.5 IRE.
This function is available for the following
signals.
With COMPUTER/COMPONENT 1 or 2 input:
- 480I
With S-VIDEO or VIDEO input:
- NTSC3.58
•
Note
Signal Adjustment (“SIG-ADJ” Menu)
(Continued)
Menu operation n Page 40
6
Checking the Input Signal
This function allows you to check the current
input signal information.