Instruction manual

17
E
Preparing and Using the Touch Pen
Inserting the battery
1. Rotate the battery cap and remove it, and then pull out the
cover.
Battery cap
2. Insertthesuppliedbattery(LR-03(“AAA”size))inthe
orientation shown, and attach the cover and battery cap.
TIPS
• IfthebatteryindicatordoesnotilluminatewhenFunction
Button1orFunctionButton2ispressed,thebatteryis
exhausted. Replace the battery with a new commercially
available battery.
• Thesuppliedbattery(LR-03(“AAA”size))maybe
exhausted in a short time, depending on how it was stored.
• Ifthetouchpenwillnotbeusedforanextendedtime,
remove the battery from the touch pen.
• Forthebattery,useanalkalinebattery.
Using the touch pen
The touch pen can be used to perform the same operations
as a mouse.
Whenthetouchpanelistouchedwiththepen,theinputmode
changestopenmode.Whentouchedwithyournger,the
input mode changes to handwriting mode. The input mode is
set by default to change automatically.
Caution
• Donotusethetouchpenforanypurposeotherthantouch
panel operation.
• Donotpresshardonthepentip.
• Donotcovertheultrasonictransmitterwithyourhandor
nger.
• Operationwillnottakeplacecorrectlyifthereisanobstacle
between the infrared transmitter/receiver and the touch pen
oryournger.Operationwillnottakeplacecorrectlyifyour
ngersoryoursleeveisnearthescreen.
• Ifthetouchpenisheldtooatagainstthescreen,the
touch position may not be correctly detected.
• Donotstorewiththepentiporfunctionbuttonpressed.
The battery will be exhausted.
• Donotusenearadevicethatemitsultrasonicwaves.The
touch pen uses ultrasonic waves and may not operate
correctly.
• Iftwotouchpanelsareusedincloseproximitytoeach
other, use handwriting mode. The touch pens will interfere
with each other and will not operate correctly.
• Ifthereisdirtorforeignmatteronthetipofthetouchpen,
removeit.Foreignmattermaydamagethescreen.
Pen tip
Function Button 2
Function Button 1
Ultrasonic transmitter
Battery indicator
Touchingwiththepentiporyournger…
Same as clicking the left mouse button.
Touchingtwicequicklyisthesameasdouble-clickingtheleft
mouse button.
PressingFunctionButton1…
Same as clicking the right mouse button.
The battery indicator illuminates.
PressingFunctionButton2…
CausesthefunctionsetinthePenSoftwaretooperateinthe
Pen Software.
The battery indicator illuminates.
Movingthepentiporyourngerwithittouchingthe
screen…
Same as dragging.
TIPS
• Thetouchpanelinputmode,theactionsofthefunction
buttons, and other settings related to touch panel operation
canbechangedinthetouchpaneldriver.Fordetails,see
theTouchPanelDriverOperationManual.
• Whendoubleclickingwithyournger,makesureyour
ngerleavesthescreensufcientlyafterthersttouch.If
thereisnotsufcientdistancebetweenyourngerandthe
screen, double clicking will not take place.
• FortheproceduresforusingthetouchpeninthePen
Software, see the Pen Software Operation Manual.
• UseFunctionButton1andFunctionButton2nearthefront
of the screen. If too far away, operation will not be possible.
• PressFunctionButton1andFunctionButton2slowly
andrmly.Ifpressedtooquickly,theactionwillnotbe
recognized.
• Ifthepentipbecomeswornordamaged,replaceit.Pull
out the old pen tip and insert a new pen tip.
Eraser
TheeraserisusedwiththePenSoftware.Fortheprocedure
for using the eraser, refer to the Pen Software Operation
Manual.
Caution
• Whenusingtheeraser,gentlybringtheclothsideinto
contact with the screen. Touching the screen with one of
thenon-clothsideswilldamagethescreen.
• Ifthereisanydirtorforeignmatteronthesurfacethat
contactsthescreen,removeit.Foreignmattermaydamage
the screen.