Owner's Manual

Installation

Rear Connector Layout (con’t)

1. Power Connection (refer to the figure in the previous page)

Use only the AC power adapter supplied with the system.

Input: 100~240V AC 1.3A

Output: 12V DC 7A

Plug the 12V AC/DC adapter (as in the figure 1 above) to the PN-

TPCi7W7’s power input jack (as in the figure 2).

2. Power Button

This button will stay lit if the PN-TPCi7W7 is powered on. If the

PN-TPCi7W7 doesn’t power up after the AC is connected, then

press this button to power up. If normal Windows shutdown is

not shutting down the PN-TPCi7W7, then press this button for

more than 4 seconds will turn off the PN-TPCi7W7. In this case,

run Disk Cleanup in the Windows next time the PN-TPCi7W7 is

powered up.