Operating instructions

38
E
Your monitor can be connected to a LAN allowing you to
control it from a PC on the LAN.
The connection requires a commercially available LAN cable
(UTP cable, Category 5, straight through).
LAN terminal
LAN cable (commercially available, straight)
Network (LAN)
Hub
TIPS
• YoumustassignanIPaddresstothemonitorbyfollowing
the procedures in “Settings to connect to a LAN”. (See the
description on the right.)
• TocontrolthemonitorviaLAN,setSTANDBYMODEto
STANDARD.
Butthemonitorcannotbeturnedon.
• IfyouwilluseRS-232CandLANcontrolsimultaneously,
maintain an interval of at least 100 ms between commands.
Controlling the Monitor with a PC (LAN)
Settings to connect to a LAN
Set the monitor’s IP address and subnet mask to match the
settings of your LAN.
ThesettingsdependonthecongurationofyourLAN.Ask
your LAN administrator for details.
■ To set on the monitor
SettheLANSETUPoptions.(Seepage27.)
After setting each item, press
RETURN
.
DHCP CLIENT
IfyourLANhasaDHCPserverandyouwishtoobtainan
addressautomatically,changethissettingtoON.
Tosettheaddressmanually,setthistoOFF.
IP ADDRESS
IftheDHCPCLIENTissettoOFF,specifyanIPaddress.
SUBNET MASK
IftheDHCPCLIENTissettoOFF,specifythesubnetmask.
DEFAULT GATEWAY
IftheDHCPCLIENTissettoOFF,specifythedefault
gateway.
If you are not using a gateway, specify “0.0.0.0”.
DNS 1
DNS 2
SpecifytheDNSserveraddressiftheDHCPCLIENTisset
toOFF.
IfyouarenotusingaDNSserver,specify“0.0.0.0”.
NETWORK NAME
Enter the device name.
■ Character input
Input characters as follows when it is necessary.
Press
ENTER
to display the text entry table.
Select a character with , and press
ENTER
to
enter. To change the characters entered, press
DISPLA
Y
(Red),
MODE
(Green),
SIZE
(Yellow).
To delete the previous character, press
MUTE
.
Whenyouaredoneenteringcharacters,select[OK]andpress
ENTER
.