PN-L752B Dismantle Instruction LCD MONITOR MODEL PN-L752B Dismantle Instruction 1
PN-L752B Dismantle Instruction Table of contents 1. Scope .................................................................................................................. 3 2. Tools for dismantling ................................................................................................ 3 3. Dismantle Procedure ................................................................................................ 3 4. Back covers ...........................................................................
PN-L752B Dismantle Instruction 1. Scope This document describes dismantling instruction according to Annex VII of Directive 2012/19/EU. 2. Tools for dismantling Below tools are required to dismantle this product. - Screw Driver - Nipper 3. Dismantle Procedure This product can be dismantled by below steps. 1. Remove Back covers (section 4) 2. Remove Printed circuit boards (section 5) 3. Dismantle LCD (section 7) 4.
PN-L752B Dismantle Instruction 4. Back covers Big back cover(x1),Middle back cover(x1),Right small back cover(x1) ,Left small back cover(x1) Can be removed by screw driver.
PN-L752B Dismantle Instruction 5. Printed circuit boards All PWBs can be removed by screw driver.
PN-L752B Dismantle Instruction 6. Battery Battery can easily be removed from the battery holder.
PN-L752B Dismantle Instruction 7. LCD Module - LCD Dismantle procedure After you have removed the PWB´s and dismantled the LCD Module please take out the cables from the LCD module. Due to direct bonding technology the front glass cannot be removed from the LCD.
PN-L752B Dismantle Instruction 8. Capacitors Electrolyte Capacitors which diameter/height is larger than 25mm is installed on Power PWB, LED driver PWB and 5V Power PWB. These capacitors can be removed by using nipper to cut the leads.
PN-L752B Dismantle Instruction 9. Parts List Parts described in Annex VII of directive 2012/19/EU are as below.