User manual
Table Of Contents
- Connecting Pin Assignments
- RS-232C Specifications and Commands
- Operating the Projector Using the PJLinkTM Protocol
- Setting up the Projector Network Environment
- Controlling the Projector via LAN
- Controlling the Projector Using Internet Explorer
- Confirming the Projector Status (Status)
- Controlling the Projector (Control)
- Setting and Adjusting the Projector (Settings & Adjustments)
- Setting the Security (Network ‐ Security)
- Making General Settings for the Network (Network - General)
- Setting for Sending E-mail when an Error Occurs (Mail ‐ Originator Settings)
- Setting Error Items and Destination Addresses to which E-mail is to be Sent when an Error Occurs (Mail ‐ Recipient Settings)
- Setting Error Items and the URL that are to be Displayed when an Error Occurs (Service & Support ‐ Access URL)
- Resetting the Lamp Timer of the Projector via LAN
- Troubleshooting
-14
5
Click “Internet Protocol Version 4
(TCP/IPv4)”, and click the
“Properties” button.
6
Confi rm or change an IP address
for the setup computer.
1 Confi rm and note the current IP
address, Subnet mask and Default
gateway.
Make sure to note the current IP address,
Subnet mask and Default gateway as you
will be required to reset them later.
2 Set temporarily as follows:
IP address: 192.168.150.3
Subnet mask: 255.255.255.0
Default gateway: (Do not input any
values.)
The factory default settings for the projector are
as follows:
DHCP Client: OFF
IP address: 192.168.150.2
Subnet mask: 255.255.255.0
Default gateway: 0.0.0.0
•
Note
7
After setting, click the “OK”
button, and then restart the
computer.
5
1
2
1
2
6
7
After confi rming or setting, proceed to “3. Setting up Network Connection for the Projector”.
Setting up the Projector Network Environment