User manual
Table Of Contents
- Connecting Pin Assignments
- RS-232C Specifications and Commands
- Operating the Projector Using the PJLinkTM Protocol
- Setting up the Projector Network Environment
- Controlling the Projector via LAN
- Controlling the Projector Using Internet Explorer
- Confirming the Projector Status (Status)
- Controlling the Projector (Control)
- Setting and Adjusting the Projector (Settings & Adjustments)
- Setting the Security (Network ‐ Security)
- Making General Settings for the Network (Network - General)
- Setting for Sending E-mail when an Error Occurs (Mail ‐ Originator Settings)
- Setting Error Items and Destination Addresses to which E-mail is to be Sent when an Error Occurs (Mail ‐ Recipient Settings)
- Setting Error Items and the URL that are to be Displayed when an Error Occurs (Service & Support ‐ Access URL)
- Resetting the Lamp Timer of the Projector via LAN
- Troubleshooting
-17
Controlling the Projector via LAN
After connecting the projector to your network, enter the projector IP address in
“Address” on Internet Explorer (version 6.0 or later) using a computer on the network to
start a setup screen that will enable control of the projector via the network.
Controlling the Projector
Using Internet Explorer
Complete connections to external
equipment before starting the operation.
(See pages 21-25 of the projector's
operation manual.)
Complete the AC cord connection. (See
page 25 of the projector's operation
manual.)
When connecting the projector to the LAN, use
a commercially available LAN cable (UTP cable,
Category 5, cross-over type). When
connecting the projector to a hub, use a
straight-through cable.
•
Note
1
Start Internet Explorer on the
computer.
2
Enter “http://” followed by the
projector IP address set by the
procedure on page
16 followed by
“/” in “Address”, and then press
the “Enter” key.
When “DHCP Client” is set to “OFF” on the
projector, IP address is 192.168.150.2. If you
did not change the IP address in “3. Setting
up a Network Connection for the
Projector” (pages
15-16), enter
“ht tp: //192.168 .150. 2/ ”.
3
A screen for controlling the
projector appears, ready for
performing various status
conditions, control, and settings.
•
1
2
3