Service manual

QT-CD210/C

– 7 –

CD SECTION

Since this CD system incorporates the following automatic

adjustment function, when the pickup is replaced, it is not

necessary to reajust it.

Since this CD unit does not need adjustment, the combination

of PWB and laser pickup unit is not restricted.

TEST MODE

While holding down the "PLAY" button, move the FUNCTION/POWER switch to "CD".

Start

Note

1. When the CD LID switch is in the OFF position, (CD LID is open) the unit will be able to enter the test mode.

However, can use the "UP/CUE" and "DOWN/REVIEW" button only.

2. You can only move the pickup.

3. The LCD display should be the same as it is for normal CD operations.

When the "PLAY" button is pressed, the laser will be lit. If the laser is lit and the "PLAY" button is pressed again,

play back will start from the current pickup position . In the playback operation, the "STOP" button is pressed,

the laser will be geve out and the playback is stopped.

Operation

The use of the "UP/CUE" button will move the pickup to the outermost position.

The use of the "DOWN/REVIEW" button will move the pickup to the innermost position.

After connecting of the 10kΩ resistor between IC802 27 pin and GND and holding down the "PLAY" button, move

the FUNCTION/POWER switch to "CD".

Start

Display

LCD MODE