Operating instructions

25
Models C709 & C717 Important: To the Operator
080222
Program the AUTO START TIME by selecting the
UP arrow symbol to move the arrow to Change.
Touch the SEL symbol to advance to the next
screen.
AUTO START TIME
00
:00
Figure 42
Use the arrow symbols to program the AUTO
START TIME by increasing or decreasing the hour
setting above the cursor. Touch the SEL symbol to
advance the cursor and program the minutes
setting. Select the SEL symbol to return to the
previous screen with the new time setting displayed.
Select the SEL symbol to exit the screen and return
to the Menu.
The STANDBY option is used to manually place the
machine in the standby mode during long, no draw
periods. Select the STANDBY screen from the
Menu. Touch the SEL symbol to activate Standby.
Discontinue Standby operation by exiting the
Manager's Menu and select the AUTO mode.
STANDBY MODE
> EXIT
Figure 43
The BRUSH CLEAN CYCLE option allows the
Manager to select the maximum number of days
between brush cleaning the machine (C717 only).
The brush clean cycle may only be changed after
the freezer has been manually cleaned, but before it
has been placed in the AUTO or STANDBY mode.
Note: This option can only be accessed through the
Service Menu for the C709.
The following message will be displayed if the
BRUSH CLEAN CYCLE option is selected when the
machine is not in a brush clean state.
BRUSH CLEAN CYCLE
No Changes Allowed
Press Any Key
Figure 44
Change the number of days between brush clean
intervals by using the arrow symbols. Touch the SEL
symbol to save the setting and exit back to the
Menu. The number of days displayed on the brush
clean counter will change to the new setting.
BRUSH CLEAN CYCLE
TIME 14 DAYS
Figure 45
Always comply with local guidelines on the number
of days allowed between brush clean cycles.
The MIX LEVEL AUDIBLE option when enabled will
alert the operator with an audible tone when there is
mix low or mix out condition. The following screen is
displayed upon selecting this option.
MIX LEVEL AUDIBLE
> Enable
Disable
Figure 46
Disable the audible tone feature by selecting the UP
arrow symbol to move the arrow to Disable. Select
the SEL symbol to save the new setting and return
to the Menu. The control panel icons for Mix Low
and Mix Out will light as the mix level drops in the
hopper but the audible tone will be disabled.