Operating instructions

Models C709 & C717 Operating Procedures

Model C709 Freezer Door Assembly (Cont'd .)

Step 2

Slide the three o-rings into the grooves on the draw

valve and lubricate. (See Figure 62.)

Figure 62

Step 3

Lightly lubricate the inside of the top of the freezer

door valve cavity. (See Figure 63.)

Figure 63

Step 4

Insert the draw valve from the top, with the draw

handle slot facing forward. (See Figure 64.)

Figure 64

Step 5

Insert the baffle rod through the beater in the

freezing cylinder. With the door seated on the

freezer studs, install the handscrews, with the longer

ones on top. Tighten equally in a criss-cross pattern

to insure the door is snug. (See Figure 65.)

Figure 65

Step 6

Position the draw handle with the adjustment screw

facing down. Slide the fork of the draw handle into

the slot of the draw valve. Secure with pivot pin.

(See Figure 66.)

Figure 66