Specifications

E-6
Recording to a Cassette Tape
Before recording:
● When recording important selections, make
a preliminary test to ensure that the desired
material is properly recorded.
● SHARP is not liable for damage or loss of
your recording arising from malfunction of
this unit.
■ Recording from the radio
1 Set the FUNCTION switch to RADIO.
2 Set the BAND SELECTOR switch to FM,
MW, SW1 or SW2.
3 Tune in to the station to be recorded.
4 Load a blank cassette into the cassette
compartment with the side to be record-
ed on facing up.
5 Press the PAUSE
66
66
6 button.
6 Press the RECORD ● button.
7 Press the PAUSE
66
66
6 button again to be-
gin recording.
To stop recording:
Press the STOP/EJECT
■
7 button.
Beat cancel switch:
If a whistling noise occurs when recording from
an MW, SW1 or SW2 station, set the BEAT
CANCEL switch to A or B, whichever gives the
best reception.
● The ALC (Automatic Record Level Control)
circuit automatically controls the level of the
input signal used for recording.
● The VOLUME, X-BASS, GRAPHIC EQUAL-
IZER and SURROUND controls may be ad-
justed with no effect on the recorded sig-
nal. (Variable Sound Monitor)
● Metal and CrO2 tapes cannot be used for
recording.
■ Recording from the built-in
microphone
1 Set the FUNCTION switch to TAPE.
2 Load a cassette into the cassette com-
partment.
3 Press the PAUSE
66
66
6 button.
4 Press the RECORD ● button.
5 Press the PAUSE
66
66
6 button again to be-
gin recording.
Notes:
● Monitoring of the recording is not possible.
● Recording from the built-in microphone is
not in stereo.
■ Erasing a recorded tape
1 Set the FUNCTION switch to LINE.
● Do not connect anything to the LINE IN and
MIXING MIC sockets.
2 Load a tape into the cassette compart-
ment with the side to be erased facing up.
3 Press the RECORD ● button.
01-E1-E9-QT-90W(S) 01.9.19, 15:297