Instruction manual

MS 201 T
English
33
Exhaust emissions are controlled by the
design of the fundamental engine
parameters and components (e.g.
carburation, ignition, timing and valve or
port timing) without the addition of any
major hardware.
Basic information
The carburetor comes from the factory
with a standard setting.
The carburetor has been adjusted for
optimum performance and fuel
efficiency in all operating states.
The high speed adjusting screw on this
carburetor can only be set within narrow
limits.
Standard setting
N Switching off the engine
N Check the air filter – clean or
replace it if necessary
N Check the spark arresting screen in
the muffler (present only in some
countries) – clean or replace it if
necessary
N Turn the high speed screw (H)
counterclockwise as far as possible
(max. 3/4 turn)
N Turn the low speed screw (L) gently
clockwise until it is firmly in its seat.
N Open the low speed screw (L) 1 full
turn
Setting the idle speed
Engine stops when idling
N Set low speed screw (L) to standard
setting
N Turn the idle speed adjusting
screw (LA) clockwise until the saw
chain begins to rotate – then turn it
back 1 1/2 turns
Engine Management Adjusting the Carburetor
H
0012BA014 KN
L
0012BA015 KN