User Manual
Table Of Contents
- PRECAUTIONS TO BE OBSERVED BEFORE AND DURING SERVICING TO AVOID POSSIBLE EXPOSURE TO EXCESSIVE MICROWAVE ENERGY
- WARNING TO SERVICE PERSONNEL
- MICROWAVE MEASUREMENT PROCEDURE
- FOREWORD AND WARNING
- PRODUCT DESCRIPTION
- GENERAL INFORMATION
- OPERATION
- TROUBLESHOOTING GUIDE
- TEST PROCEDURES
- [1] Procedure A: MAGNETRON ASSEMBLY TEST
- [2] Procedure B: POWER TRANSFORMER TEST
- [3] Procedure C: HIGH VOLTAGE RECTIFIER TEST
- [4] Procedure D: HIGH VOLTAGE CAPACITOR TEST
- [5] Procedure E: THERMAL CUT OUT TEST
- [6] Procedure F: SECONDARY INTERLOCK SWITCH TEST
- [7] Procedure F: PRIMARY INTERLOCK SYSTEM TEST
- [8] Procedure G: MONITOR SWITCH TEST
- [9] Procedure H: BLOWN MINITOR FUSE TEST
- [10] Procedure I: NOISE FILTER TEST
- [11] Procedure J: CONTROL PANEL ASSEMBLY TEST
- [12] Procedure L: RELAY TEST
- [13] Procedure M: FOIL PATTERN ON THE PRINTED WIRING BOARD TEST
- TOUCH CONTROL PANEL ASSEMBLY
- PRECAUTIONS FOR USING LEAD-FREE SOLDER
- COMPONENT REPLACEMENT AND ADJUSTMENT PROCEDURE
- [1] WARNING
- [2] OUTER CASE REMOVAL
- [3] POWER TRANSFORMER REMOVAL
- [4] HIGH VOLTAGE RECTIFIER ASSEMBLY AND HIGH VOLTAGE CAPACITOR REMOVAL
- [5] MAGNETRON REMOVAL
- [6] CONTROL PANEL ASSEMBLY REMOVAL
- [7] OVEN LAMP AND LAMP SOCKET REMOVAL
- [8] POSITIVE LOCK CONNECTOR (NO-CASE TYPE) REMOVAL
- [9] ANTENNA MOTOR REMOVAL
- [10] COOLING FAN MOTOR REMOVAL
- [11] POWER SUPPLY CORD REPLACEMENT
- [12] DOOR SENSING SWITCH/SECONDARY INTERLOCK SWITCH AND MONITOR SWITCH REMOVAL
- [13] DOOR SENSING SWITCH/SECONDARY INTERLOCK SWITCH AND MONITOR SWITCH ADJUSTMENT
- [14] DOOR PARTS REMOVAL
- [15] ANTENNA MOTOR SHAFT REPLACEMENT
- [16] INSTALLATION OF CERAMIC SHELF
- CIRCUIT DIAGRAMS
- Parts List
No part of this publication may be reproduced,
stored in a retrieval system, or transmitted in
any form or by any means, electronic, mechanical,
photocopying, recording, or otherwise, without
prior written permission of the publisher.
COPYRIGHT © XXXX BYSHARP CORPORATION
ALL RIGHTS RESERVED.
COPYRIGHT © 2006 BY SHARP CORPORATION
ALL RIGHTS RESERVED.
No part of this publication may be reproduced, stored
in retrieval systems, or transmitted in anyform or by
any means, electronic, mechanical, photocopying, re-
cording, or other wise, without prior written permission
of the publisher.