Technical data

13773-001
20-30
Page 1
SOLVENT CLEANING
1. DESCRIPTION
This section covers solvent cleaning procedures for metallic and non-metallic materials. These procedures
may be used for general cleaning when solvents are required and must be used to clean surfaces prior to
the application of adhesive, resin, or sealants.
WARNING:
Cleaning solvents are toxic and flammable. Therefore, special precautions must be
used whenever solvents are used for any purpose.
Always follow the solvent manufacture’s directions.
A fire extinguisher must be immediately available when using solvents.
Adequate ventilation shall be provided and fresh air masks shall be used in all closed
areas with marginal or insufficient ventilation.
Skin protection in the form of protective gloves and eye protection must be worn
when pouring or applying solvents.
When solvent cleaning closed areas such as fuel tanks, eliminate spark hazards, elec-
trically ground the aircraft, and fill the enclosed area with an inert gas such as argon
or nitrogen. Apply the inert gas continuously until the tank is clean and dry.
Always check the MSDS for the solvent being used for additional requirements and/or
precautions to be followed when using a particular solvent.
Special procedures may be required to dispose of used solvents.
30 Nov 2000