Technical data

13773-001
21-60
Page 530 Nov 2000
(l) Install MFD. (Refer to 34-40)
(m) Install co-pilot kick plate. (Refer to 25-10)
(n) Install engine cowling. (Refer to 71-10)
(o) Verify proper operation of temperature controls and MFD.
(3) Adjustment - Heat Box Control Cable
(a) Remove MFD. (Refer to 34-40)
(b) Remove engine cowling.
(c) Loosen the cable stop bolt from the inner core wire (located above the heat box actuation
arm).
(d) Loosen the heat box actuation arm cable stop bolt.
(e) Rotate control knob to full heat position.
(f) Position heat box flap in the full heat position by pushing down on the control arm.
(g) Secure the heater cable core wire to the heat box actuation arm by tightening the bolt into
the actuation arm cable stop.
(h) Rotate control knob to the full off position.
(i) Slide the lower cable stop up to the outer cable housing and secure cable stop bolt.
(j) Install MFD and engine cowling. (Refer to 34-40)
(k) Verify proper operation of temperature controls and MFD.