Technical data

13773-001
24-30
Page 730 Nov 2000
B. Alternator 2 (Aft Alternator)
(1) Removal
(a) Verify ignition switch is in the off position and remove the key. (Refer to POH)
(b) Ensure BAT 1, BAT 2 and AVIONICS master switches are in the off position.
(c) Remove engine cowling. (Refer to 71-10)
(d) Disconnect battery and insulate battery terminals to prevent accidental connection. (Refer
to 24-30)
(e) Identify each wire from the alternator terminals and disconnect.
(f) Remove the alternator mounting nuts and washers. Remove alternator 2 from the engine.
(2) Installation
(a) Place alternator and a new gasket into position and loosely secure using the existing
washers, lockwashers, and nuts.
(b) Secure alternator mounting hardware.
(c) Connect the alternator wires to the appropriate terminal.
(d) Connect battery.(Refer to 24-30)
(e) Install engine cowling. (Refer to 71-10)