Technical data

13773-001
24-50
Page 330 Nov 2000
2. MAINTENANCE PRACTICES
A. Circuit Breakers
(1) Removal - Circuit Breakers
(a) Verify the ignition switch is in the OFF position and remove the key.
(b) Disconnect both batteries (BAT 1 and BAT 2). (Refer to 24-30)
(c) Remove the two aft screws securing circuit breaker panel to the center console. Swing the
panel open.
(d) Identify and disconnect all wires to the selected breaker and/or bus.
(e) Remove the retaining ring from the circuit breaker and remove the breaker.
Note: It may be necessary to loosen more than one circuit breaker and/or bus bar
to remove the selected breaker and/or bus bar.
(2) Installation - Circuit Breakers
(a) Install the circuit breaker(s) into position on the panel and secure.
(b) Identify and connect all wires to the selected breaker(s).
(c) Tighten the two aft screws securing circuit breaker panel to the center console.
(d) Connect the battery. (Refer to 24-30)
B. Switches
(1) Removal - Bolster Panel Switches
(a) Verify the ignition switch is in the OFF position and remove the key.
(b) Disconnect the battery. (Refer to 24-30)
(c) Remove the Kick Plate to gain access to the underside of the switches.
(d) Remove the screws and washers securing Bolster Panel to the Flight Instrument Panel.
(e) Identify and disconnect all wires to the selected switch.
(f) Compress the retainers on the selected switch and push up to remove.
(2) Installation - Bolster Panel Switches
(a) Compress the retainers on the selected switch and push down into position.
(b) Identify and connect all wires to the selected switch.
(c) Secure Bolster Panel to the Flight Instrument Panel with screws and washers.
(d) Secure the Kick Plate.
(e) Connect the battery. (Refer to 24-30)