Manualshelf

Technical data

ManualsBrandsSharp ManualsDomestic AppliancesR-22AMM
361362363364365366367368369370
13773-001
25-10
Page 331 Jul 2001
C. Rear Seat Harness
(1) Removal - Rear Seat Harness (See Figure 25-102)
(a) Remove the bolt, washer, bushing, washer, and nylon self-locking nut from lower outboard
harness mount.
(b) Remove the bolt, washer, bushing, washer, and self-locking nut from lower (central) har-
ness mount.
(c) Remove the aft bulkhead trim panel and the rear headliner. (Refer to 25-50)
(d) Remove the bolts, washers, and self-locking nuts from upper seat harness mount.
(2) Installation - Rear Seat Harness
(a) Install the two lower (central) lap harnesses into the lower (central) harness mount.
(b) Insert the bushing, bolt, and washer through the harness mount and both harnesses.
(c) Install flat washer and self-locking nut. Tighten self-locking nut.
WARNING:
Inertia reel must be installed with harness coming off the top side of
inertia reel. The inertia reel plate must be installed on the underside of
mount.
(d) Install inertia reel plate on the underside of mount and secure with three bolts, washers,
and self-locking nuts.
(e) Secure aft bulkhead trim panel. (Refer to 25-50)
(f) Install the lower outboard harness mount, and secure with bolt, washer, bushing, washer,
and nylon self-locking nut. Torque to 150 inch pounds.