Technical data

13773-001
25-10
Page 531 Jul 2001
D. Trim
(1) Removal - Glareshield Assembly
(a) Remove glareshield mounting screws located just inside the aft edge on the left-hand side
of the glareshield.
(b) Remove glareshield mounting screws located just outside the aft edge on the right-hand
side of the glareshield.
(c) Disconnect GPS antenna lead located underneath the glareshield.
(d) Disconnect glareshield light wire harness and remove glareshield.
(2) Installation - Glareshield Assembly
(a) Place glareshield into position and connect glareshield light wire harness.
(b) Connect GPS antenna lead.
(c) Install glareshield mounting screws.
(3) Removal - Cabin Headliner
(a) Remove CAPS cover and insert safety pin.
(b) Remove door-seal.
(c) Remove both A-pillar and B-pillar trim panels.
(d) Using a non-magnetic screwdriver, remove the screws securing the compass. Remove
compass assembly. (Refer to 34-20)
(e) Remove upper windshield interior trim. Disconnect wires to switches and lights.
(f) Remove aft bulkhead trim panel.
(g) Remove aft headliner.
(h) Remove rear passenger light access panel and disconnect wires to the switch and light.
(i) Remove the four screws securing the headliner and remove the headliner.
(4) Installation - Cabin Headliner
(a) Using the existing screws, secure the headliner.
(b) Connect wires to the rear passenger light access panel switch and light. Secure rear pas-
senger light access panel.
(c) Install and secure the aft headliner.
(d) Install and secure the aft bulkhead trim panel.
(e) Connect wires to switches, compass, and lights in upper windshield trim. Secure trim.
(f) Install and secure the compass. (Refer to 34-20)
(g) Install and secure A-pillar and B-pillar trim panels.
(h) Place door-seal into position and secure.
(i) Remove safety pin from CAPS handle and place CAPS cover into position.
(5) Removal - A-Pillar and B-pillar Trim
(a) Remove sunvisor.
(b) Remove screws securing trim to fuselage. Remove trim.
(6) Installation - A-Pillar and B-pillar Trim
(a) Place trim into position and secure pillar trim with screws.
(b) Install and secure sunvisor.
(7) Removal - Lower Windshield Trim
(a) Remove glareshield. (Refer to 25-10)
(b) Remove both forward door-seals. (Refer to 52-10)
(c) Remove the upper and lower A-pillar trim from both sides. (Refer to 25-10)
(d) Place a cover over the inside of the windshield and remove the lower windshield trim.