Technical data

13773-001
25-10
Page 8 31 Jul 2001
(29) Removal - Side Duct Cover Panel (Refer to 25-10)
(a) Remove door seal. (Refer to 52-10)
(b) Lift forward edge of side duct cover and slowly release the hook and loop fasteners.
Remove side duct cover.
(30) Installation - Side Duct Cover Panel
(a) Place side duct cover into position and secure. Firmly push on trim in areas of hook and
loop fasteners.
(b) Install door seal. (Refer to 52-10)
(31) Removal - Right Aft Console Trim
(a) Unscrew friction control knob and remove.
(b) Remove co-pilot seat. (Refer to 25-10)
(c) Remove Right Mid Console Trim screws and remove trim. (Refer to 25-10)
(d) Remove Right Aft Console Trim screws and remove trim.
(32) Installation - Right Aft Console Trim
(a) Secure Right Aft Console Trim with screws.
(b) Secure Right Mid Console Trim. (Refer to 25-10)
(c) Secure co-pilot seat. (Refer to 25-10)
(d) Secure friction control knob.
(33) Removal - Left Aft Console Trim
(a) Remove pilot seat. (Refer to 25-10)
(b) Lift forward edge of the Alternate Static Source cover plate and slowly release the hook
and loop fasteners. Remove cover plate.
(c) Remove Left Mid Console Circuit Breaker Trim and remove trim. (Refer to 25-10)
(d) Remove Left Aft Console Trim screws and remove trim.
(34) Installation -Left Aft Console Trim
(a) Secure Left Aft Console Trim with screws.
(b) Secure Left Mid Console Circuit Breaker Trim. (Refer to 25-10)
(c) Place Alternate Static Source cover plate into position and firmly push on trim in areas of
hook and loop fasteners.
(d) Secure pilot seat. (Refer to 25-10)
E. Kick Plate
(1) Removal - Kick Plate
(a) Remove screws securing kick plate to the lower console rib.
(b) Remove clamp from conditioned air duct and remove duct.
(c) Remove kick plate.
(2) Installation - Kick Plate
(a) Secure conditioned air duct to vent.
(b) Place kick plate into position and secure with screws.
F. Sunvisors and Mounting Brackets
(1) Removal - Sunvisors and Mounting Brackets
(a) Remove the screws securing the sunvisor to the mounting bracket.
(b) Remove screws securing mounting bracket to fuselage.
(2) Installation - Sunvisors and Mounting Bracket
(a) Secure mounting bracket to fuselage.
(b) Place sunvisor into position and secure with screws.