Technical data

13773-001
27-10
Page 2 30 Nov 2000
(k) Remove cotter pins and washers securing pulley guard pins to forward pulley gang bracket
and remove pins.
(l) Remove safety wire securing aileron cable to console actuation pulley.
(m) Loosen nuts securing pulley keepers to console.
Note: Attach string to end of cable prior to removing from airplane to facilitate
cable routing during installation.
(n) Attach string to end of forward aileron cable below access hole CF3C and pull cable
through. Remove cable from airplane.
(o) Attach string to end of LH aileron cable below access hole CF4C and pull cable through.
Remove cable from airplane. Repeat procedure for RH aileron cable.
(2) Installation - Aileron System Cables
(a) At access hole CF3C, route forward aileron cable to forward pulley gang, up to console
actuation pulley and back to access hole CF3C.
(b) At access hole CF4C, route LH aileron cable to kick-out pulley, cross-over pulley, aileron
actuation pulley, and back to center of fuselage floor. Repeat procedure for RH aileron
cable.
(c) Secure forward aileron cable to console actuation pulley with safety wire.
(d) Tighten nuts securing pulley keepers to center console.
(e) At forward pulley gang bracket, verify cable routing, insert pulley guard pins, and install
washers and cotter pins.
(f) For LH aileron cable, verify cable routing through flap-hinge fairleads, kick-out, and cross-
over pulleys, insert clevis pins, and install washers and cotter pins. Repeat procedure for
RH aileron cable.
(g) At LH aileron actuation pulley, verify cable routing, position cable guard to pulley bracket,
and install washer and bolt. Safety wire aileron cable to pulley. Repeat procedure at RH
aileron actuation pulley.
WARNING:
Position turnbuckle so that at aileron neutral position, turnbuckle is
centered between LH and RH longerons and at full left and full right
aileron deflection swaged cable end does not contact either longeron.
(h) Install turnbuckles on LH and RH aileron cables.
(i) Install rudder/aileron interconnect to RH aileron cable. (Refer to 27-20)
(j) Perform Aileron System Rigging Adjustment/Test. (Refer to 27-10)
(k) Install ailerons. (Refer to 57-50)