Technical data

13773-001
27-10
Page 530 Nov 2000
WARNING:
Turning control yoke counterclockwise should put left aileron trailing
edge in raised position. If this is not true, system is improperly rigged.
The system MUST BE RIGGED CORRECTLY. Check for crossed or
wrapped cables.
(p) Rotate control yoke counterclockwise placing LH aileron in raised position.
Note: Aileron removal may be necessary to facilitate aileron travel limits/stop
adjustments.
(q) Adjust stop screws at LH aileron actuation pulley to allow 12.5° +/- 1° up and down aileron
travel. In addition, adjust stops screws at LH aileron actuation pulley so that for full left roll
input;
1
the LH lower aileron stop contacts first with 12.5° +/- 1° aileron up travel,
2
the RH upper aileron stop shows a 0.035 inch (0.89 mm) gap between stop and pul-
ley bearing,
3
secondary stop mounted on co-pilot control yoke assembly shows a 0.070 inch (1.8
mm) gap between stop and center console.
(r) Fasten inclinometer to RH aileron and set at 0°
(s) Adjust stop screws at RH aileron actuation pulley to allow 12.5° +/- 1° up and down aileron
travel. In addition, adjust stops screws at RH aileron actuation pulley so that for full right
roll input;
1
the RH lower aileron stop contacts first with 12.5° +/- 1° aileron up travel,
2
the LH upper aileron stop shows a 0.035 inch (0.89 mm) gap between stop and pul-
ley bearing,
3
secondary stop mounted on pilot control yoke assembly shows a 0.070 inch (1.8
mm) gap between stop and center console.
4
Verify trim cartridge minimum rod end thread engagement of 0.312 inch (0.79 cm).
Tighten jam nuts.
(t) Perform Roll Trim Inspection/Check. (Refer to 27-10)
(u) Install access panels and carpet. (Refer to 6-00)
(v) Install passenger seats. (Refer to 25-10)
(w) Install MFD. (Refer to 34-40)
(x) Install kick plate. (Refer to 25-10)
(4) Inspection/Check - Aileron System Rigging (See Figure 27-102)
Note: If the following aileron leading edge, overlap, and neutral position gap inspections
do not fall within the specified clearances, contact Cirrus Design Customer Ser-
vice Department for disposition.
(a) Acquire necessary tools, equipment, and supplies.
Description P/N or Spec. Supplier Purpose
6" Scale - Any Source Aileron Rigging
Inclinometer PRO360 Maclanburg Duncan Deflection Angle
Tensiometer BT-33-75D Kent Moore Cable Tension