Technical data

13773-001
5-20
Page 11
5. Walkway
Visual Inspection for condition.
5-20 ❍
6. Aileron Surfaces
Visual Inspection for distortion, and condition.
5-20 ❍
7. Aileron System Rigging
Perform Inspection/Check for gap tolerances, cable tension, system
alignment, and security.
27-10 ❍
8. Aileron Actuation Arm
Visual Inspection for safetying, and condition.
5-20 ❍
9. Aileron Hinges, Hinge Bolts, Bearings, and Attachments
Visual Inspection for security, freeplay, and binding.
5-20 ❍
10. Aileron System
Check operation for travel and freedom of movement.
5-20 ❍
11. Flap System Rigging
Perform Inspection/Check for gap tolerances, system alignment,
and security.
27-50 ❍
12. Flap Hinges, Hinge Bolts, Bearings, and Attachments
Visual Inspection for wear security, freeplay, and binding.
5-20 ❍
13. Flap System
Operational Inspection for travel and freedom of movement.
5-20 ❍
14. Fuel Lines
Visual Inspection for chaffing, obstruction, security, and general con-
dition.
5-20 ❍
15. Fuel Tank Vents
Visual Inspection for condition and obstruction.
5-20 ❍
16. Stall Warning Water Trap
Drain and perform Visual Inspection for condition.
27-51 ❍
17. Air Ducts, Electrical Leads, Lines, and Attaching Parts
Visual Inspection for security, routing, chafing, deterioration, wear,
and correct installation.
5-20 ❍
18. Pitot Mast and Static Lines
Visual Inspection for security, condition, and obstruction.
5-20 ❍
Landing Gear Group
Chap-Sect
Reference
Interval
100 Special
Initials
1. Wheel Fairings
Remove, clean and perform Visual Inspection for cracking, rubbing,
and general condition.
32-00 ❍
Wing Group (Continued)
Chap-Sect
Reference
Interval
100 Special
Initials
31 July 2001