Technical data

13773-001
27-10
Page 1330 Nov 2000
(3) Inspection/Check - Control Yoke Assembly
(a) Remove seat. (Refer to 25-10)
(b) Remove kick plate. (Refer to 25-10)
(c) Verify zero vertical play exists between yoke tube and V-grooved-guide wheels.
(d) Verify V-grooved-guide wheel bolts torqued to 50-55 inch lb (5.5-6.1 Nm).
(e) Verify positive clearance and proper operation of control yoke assembly through full range
of motion.
(f) Verify yoke movement free of resistance.
(g) Verify yoke tubes/bearing free of grit build-up.
(h) Verify engagement of jam nuts on control yoke assembly rod ends.
(i) Verify proper installation of safety wires and cotter pins on all fasteners.
(j) Install kick plate. (Refer to 25-10)
(k) Install seat. (Refer to 25-10)
F. Aileron Push/Pull Rods (See Figure 27-104)
(1) Removal - Aileron Push/Pull Rods
(a) Remove kick plate. (Refer to 25-10)
(b) Remove MFD. (Refer to 34-40)
(c) Remove cotter pin, castellated nut, washers, and bolt securing aileron push/pull rod to
aileron actuation pulley.
(d) Remove cotter pin, castellated nut, washers, and bolt securing aileron push/pull rod to
control yoke aileron actuation bracket and remove push/pull rod from airplane.
(2) Installation - Aileron Push/Pull Rods
(a) Position aileron push/pull rod to control yoke aileron actuation bracket and install bolt,
washers, castellated nut, and cotter pin.
(b) Install bolt, washers, castellated nut, and cotter pin securing aileron push/pull rods to aile-
ron actuation pulley.
(c) Install MFD. (Refer to 34-40)
(d) Install kick plate. (Refer to 25-10)
G. V-Grooved-Guide Wheel (See Figure 27-104)
(1) Removal - V-Grooved-Guide Wheel
(a) Remove control yoke assembly. (Refer to 27-10)
(b) Remove bolt, nut, washers, bearing tie plate, and spacer securing V-grooved-guide wheel
to yoke assembly.
(2) Installation - V-Grooved-Guide Wheel
(a) Position spacers, washers, V-grooved-guide wheels, and yoke tube on bearing mount and
loosely secure with bolts and nuts.
(b) Perform V-grooved-guide wheel Adjustment/Test. (Refer to 27-10)
(c) Install control yoke assembly. (Refer to 27-10)
(3) Adjustment/Test - V-Grooved-Guide Wheel
(a) On bottom, aft side of bearing mount, loosen jam nut and adjust hex screw so zero vertical
play exists between yoke tube and V-grooved-guide wheel.
(b) Repeat step (a) on forward hex screw.
(c) When no vertical play exist between yoke tube and V-grooved-guide wheels, torque bear-
ing nuts to 50-55 inch lb (5.5-6.1 Nm). After torquing bearing nuts to proper spec, check for
vertical play between yoke tube and V-grooved-guide wheels. If play exists, loosen bearing
nuts and repeat Adjustment/Test.