Technical data

13773-001
27-30
Page 8 30 Nov 2000
B. Forward Elevator Push/Pull Rod (See Figure 27-303)
(1) Removal - Forward Elevator Push/Pull Rod
(a) Remove seat. (Refer to 25-10)
(b) Remove kick plate. (Refer to 25-10)
(c) Remove mid-console trim panel. (Refer to 25-10)
(d) Remove cotter pin, castellated nut, washers, and bolt securing elevator push/pull rod end
to control-yoke elevator stop.
(e) Remove cotter pin, castellated nut, washers, and bolt securing elevator push/pull rod end
to torque tube end-fitting weldment and remove elevator push/pull rod from airplane.
(2) Installation - Forward Elevator Push/Pull Rod
(a) Position elevator push/pull rod to control-yoke stop and install bolt, washers, castellated
nut, and cotter pin.
(b) Position elevator push/pull rod to torque tube end-fitting weldment and install bolt, wash-
ers, castellated nut, and cotter pin.
(c) Install mid-console trim panel. (Refer to 25-10)
(d) Install kick plate. (Refer to 25-10)
(e) Install seat. (Refer to 25-10)
C. Elevator Torque Tube (See Figure 27-303)
(1) Removal - Elevator Torque Tube
(a) Remove MFD. (Refer to 34-40)
(b) Remove pilot and co-pilot seats. (Refer to 25-10)
(c) Remove kick plate. (Refer to 25-10)
(d) Remove mid-console trim panels from LH and RH sides. (Refer to 25-10)
(e) Gain access to torque tube coupler through MFD opening and remove nut, washers, and
bolt securing torque tube coupler to elevator torque tube.
(f) Remove nut, washers, and bolt securing elevator torque tube to end-fitting weldment. Dis-
connect end-fitting weldment from elevator torque tube.
(g) Slide torque tube outboard to disconnect from coupler then slide tube inboard to remove
from console bearing plate.
(2) Installation - Elevator Torque Tube
(a) From the inboard side of console, insert elevator torque tube into console bearing plate,
then position and slide the torque tube into the elevator coupler and install bolt, washer,
and nut.
(b) Install bolt, washers, and nut securing the end-fitting weldment to elevator torque tube.
(c) Install forward center console trim panels. (Refer to 25-10)
(d) Install kick plate. (Refer to 25-10)
(e) Install pilot and co-pilot seats. (Refer to 25-10)
(f) Install MFD. (Refer to 34-40)