Technical data

13773-001
28-20
Page 730 Nov 2000
(f) Place one new seal on each side of banjo fitting and slide banjo fitting bolt through banjo
fitting. Finger-tighten banjo fitting bolt.
(g) Support banjo fittings and secure all fuel supply and return lines (with grommets) to the
corresponding fitting.
CAUTION: Always support banjo fittings during the torquing procedure to prevent dam-
aging the fuel supply lines, return lines, and selector valve assembly.
Always use new seals to help prevent fuel leaks.
Note: The fuel line grommets must lay flat against the interior and exterior sur-
faces of the panel. Fuel line grommets must seal all fuel and vapors inside
fuel selector valve housing.
(h) Support banjo fittings and tighten the small banjo fitting bolts to 10 foot-pounds (13 Nm).
(i) Support banjo fittings and tighten the large banjo fitting bolts to 20 foot-pounds (26 Nm).
(j) Safety wire all banjo fitting bolts. (Refer to 20-10)
(k) Fay surface seal upper selector valve panel and secure with screws and washers. (Refer
to 20-10)
(l) Connect the fuel selector linkage together and secure with three hex head bolts, washers,
and locknuts. Washers must be installed against locknuts.
CAUTION: Gaskets must be installed properly (flat) to prevent leakage of any fuel or
vapors. Gaskets must have overlap on all sides.
(m) Fay surface seal front fuel selector valve panel and secure with screws and washers.
(Refer to 20-10)
(n) Pressure check complete fuel system. (Refer to 20-10)
(o) Secure both fuel selector valve side panels and gaskets with screws, washers and lock-
nuts.
(p) Inspect selector valve and enclosure for any signs of potential fuel leakage. Repair any
leaks found immediately.
(q) Secure console support side brackets.
(r) Secure both pieces of mid console trim. (Refer to 25-10)
(s) Install and secure crew seats and mounting hardware. (Refer to 25-10)
(t) Connect battery. (Refer to 24-30)