Technical data

13773-001
28-20
Page 10 30 Nov 2000
CAUTION: Always support fittings during the torquing procedure to prevent damaging
the fuel supply line, return line, or selector valve assembly.
Note: The fuel line grommets must lay flat against the interior and exterior sur-
faces of the panel. Fuel line grommets must seal all fuel and vapors inside
fuel selector valve housing.
(h) Support fittings and secure the forward fuel supply and return line (with grommets) to the
corresponding fitting.
CAUTION: Gaskets must be installed properly (flat) to prevent leakage of any fuel or
vapors. Gaskets must have an equal amount of overlap on all sides.
(i) Fay surface seal front fuel selector valve panel and secure with screws and washers.
(Refer to 20-10)
CAUTION: Gaskets must be installed properly (flat) to prevent leakage of any fuel or
vapors. Gaskets must have an equal amount of overlap on all sides.
(j) Secure both fuel selector valve side panels and gaskets with screws, washers and lock-
nuts.
(k) Inspect both enclosures for any signs of potential fuel leakage. Repair any leaks found
immediately.
(l) Secure console support side brackets.
(m) Pressure check complete fuel system. (Refer to 20-10)
(n) Secure both pieces of mid console trim. (Refer to 25-10)
(o) Install and secure carpet, crew seats, and mounting hardware. (Refer to 25-10)
(p) Connect battery. (Refer to 24-30)