Technical data

13773-001
33-10
Page 4 30 Nov 2000
3. MAINTENANCE PRACTICES
A. Cabin Lights
(1) Removal - Glareshield Light Strip
(a) Open (pull) the CABIN LIGHTS circuit breaker.
(b) Remove glareshield. (Refer to 25-10)
(c) Locate and mark the outer edges of the light strip.
(d) Remove the retaining clips.
(e) Gently pull the light strip from the glareshield.
(2) Installation - Glareshield Light Strip
(a) Place the lighting strip into position and secure with clips.
(b) Install glareshield. (Refer to 25-10)
(c) Reset the CABIN LIGHTS circuit breaker.
(d) Verify proper operation of lights.
(3) Removal - Cabin Eyeball Light and Switch
(a) Open (pull) the CABIN LIGHTS circuit breaker.
(b) Remove cabin headliner. (Refer to 25-10)
(c) Identify and disconnect cabin eyeball light and switch wire harnesses.
(d) Depress mounting tabs and push the switch and light out of the headliner.
(4) Installation - Cabin Eyeball Light and Switch
(a) Push the cabin eyeball light and switch into the headliner.
(b) Identify and connect wire harnesses.
(c) Install cabin headliner. (Refer to 33-10)
(d) Reset the CABIN LIGHTS circuit breaker.
(e) Verify proper operation of light and switch.
(5) Removal - Cabin Dome Light
(a) Open (pull) the CABIN LIGHTS circuit breaker.
(b) Gently pry the lens off of the light base.
(c) Remove cabin headliner. (Refer to 25-10)
(d) Identify and disconnect the cabin dome light wire harness.
(e) Remove the cabin dome light retaining screws.
(6) Installation - Cabin Dome Light
(a) Secure the cabin dome light to headliner with screws and nuts.
(b) Connect dome light wire harness.
(c) Install cabin headliner. (Refer to 33-10)
(d) Secure lens to dome light.
(e) Reset the CABIN LIGHTS circuit breaker.
(f) Verify proper operation of light and switch.