Technical data

13773-001
33-40
Page 2 30 Nov 2000
(3) Adjustment - Landing Light
Note: The airplane must be on a level and flat surface prior to adjusting the beam of light
from the landing light. There must be a vertical wall or door in front of the landing
light lens.
(a) Check and adjust tire pressure and fuel level if necessary. (Refer to 12-10)
Note: To aid in obtaining an accurate adjustment, each fuel tank must have the
same amount of fuel in it. Measurement will be taken from the center of
landing light lens to the center of the illuminated pattern on the wall.
(b) Position airplane 112 inches away from a vertical wall or door.
(c) Place wheel chocks in place.
(d) Place a small piece of tape on the vertical wall or door 40 inches high and directly in line
with the landing light lamp.
(e) Turn on landing light. Verify tape is centrally located in beam. The landing light beam
should be centrally illuminating the tape placed on the wall or door.
(f) If the beam is too high, tighten the bottom adjuster screws. If necessary loosen the top
adjuster screws.