Technical data

13773-001
33-40
Page 730 Nov 2000
(b) Connect the strobe light wire harness.
(c) Secure the lens retainer to the base plate with screws.
(d) Reset the Strobe Lights and NAV Lights circuit breakers.
(e) Ensure proper Anti-collision Strobe Light operation.
(7) Removal - Strobe Light Module
(a) Place the Strobe light and NAV light switches in the “off” position.
(b) Pull the Strobe Lights and NAV Lights circuit breakers to open the circuit.
(c) Remove wing tip. (Refer to 57-20)
(d) Locate and identify the module wire harness.
(e) Identify and locate the four bolts, washers, and spacers used to secure the module.
(f) Remove the screws securing the module and rubber sheet to the wing tip.
(8) Installation - Strobe Light Module
(a) Place the module, bolts, washers, and spacers in position as noted from disassembly.
(b) Secure bolts holding module to wing tip.
(c) Connect the module wire harness.
(d) Install wing tip. (Refer to 57-20)
(e) Reset the Strobe Lights and NAV Lights circuit breakers.
(f) Ensure proper Anti-collision Strobe Light operation.