Technical data

13773-001
34-40
Page 8 31 July 2001
(f) Install center headliner. (Refer to 25-10)
(g) Fillet seal antenna perimeter. (Refer to 20-10)
H. Stormscope System Tests
(1) Test - Stormscope System
(a) Set BATTERY and AVIONICS master switches to ON position.
(b) On MFD, press top button to enter Software Main menu.
(c) Press the CHECKLIST button.
(d) Press the END PROGRAM button.
(e) At left/right button pair, press left button to highlight END.
(f) Press the SEL button to End Program.
(g) Press the SETUP/USER GRAPHICS button.
(h) Press the SEL button to select no Demo.
(i) At left/right button pair, press left button to highlight YES.
(j) Press the SEL button to select Yes.
(k) Press the SYSTEM CONFIGURATION button.
(l) Press the ACK button to move cursor down to STORMSCOPE selection (11 times).
(m) Press the NEXT button to highlight 1 for Stormscope ON.
(n) Press the SEL button to Exit menu.
(o) At left/right button pair, press left button to highlight YES.
(p) Press the SEL button to select Yes.
(q) Press the END button.
(r) Press the DIAGNOSTICS button.
(s) Press the STORMSCOPE button.
(t) Press the HEADING STABILIZATION button.
(u) At left/right button pair, press left button to highlight ENABLE.
(v) Press the SEL button to select Yes.
(w) Press the RESET ANTENNA CONFIGURATION button.
(x) At left/right button pair, press left button to highlight TOP.
(y) Press the SEL button to select Yes.
(z) Press the CONFIGURATION/HEADING PAGE button.
CAUTION: If configuration values do match those below, call Cirrus Design Customer
Service Department.
(1) Verify values and jumper setting match the following:
Hdg: XYZ: J3 - 1 Jumper
J2 - 2 Open
Hdg Valid Flag No Fla
Flag Sense + vld
J3 - 4 Jumper
Hdg Value ### (Value should match HSI reading)
Inhibit Line Off