Technical data

13773-001
51-30
Page 10 30 Nov 2000
(e) Remove all exterior access panels except for the fuel system access panels.
(f) Remove wing tip fairings and landing gear fairings. (Refer to 57-20), (Refer to 32-10)
(g) Remove anti-collision strobe light assemblies from wing tip fairings. (Refer to 33-40)
(h) Remove upper and lower engine cowlings. (Refer to 71-10)
(i) Remove lower engine cowling access panel.
(j) Remove oil access door.
Note: Only paint the exterior surface of the oil access door.
(k) Remove VOR antenna wicks and rubber grommets.
(l) Remove baggage door. Remove interior trim from baggage door. (Refer to 52-30)
(m) Remove cabin doors. Remove interior trim from cabin doors. (Refer to 52-10)
(n) Mask off the exterior surface of the windows, extending mask area to the door skin edge.
Note: Do not paint sealant region between window and door skin.
(o) Mask off the outside air temperature (OAT) probe, tiedowns, fuel vents, fuel caps, static
ports, antennas, interior surfaces of access panels, sealant region between window and
door skin, flexible plastic fairing on nose landing gear slot, and pitot tube.
(p) Mask off oil access door latches and camlocks.
Note: Mask off only the part of the camlock that moves.
(q) Mask off latch and hinge area on the lower engine cowling access panel and the oil
access door.
(r) Mask off airplane data plate on empennage.
(s) Mask bearings on lower vertical stabilizer hinge (rudder), aileron hinges, rod end bearings
on flap actuation link, and rod end on aileron actuation arm.
(t) Mask off push-pull tube for rudder actuation.
(u) Mask off landing gear, engine, propeller/spinner, access panel flanges, and the threads of
the VOR antenna.
(v) Mask off openings of doors at the inner mating surface.
(w) Mask off door pins (stainless) and plastic door jamb pin receivers.
Note: Do not paint plastic door jamb pin receivers.
(x) Mask off cabin door handle and exterior exposed parts that rotate with the handle. Mask
off or remove door locks.
Note: Mask off all surfaces that do not require top coat or where top coat is not
permitted.