Technical data

13773-001
52-10
Page 4 30 Nov 2000
(3) Removal - Cabin Door Latching Mechanism
Note: The external handle can be removed by just removing the roll pin from the
interior handle shaft. Always use the correct size pin punch when removing
roll pins.
(a) Remove the screw and washer securing the interior handle to the interior handle shaft.
(b) Remove door panel screws.
(c) Remove inner door panel by gently pulling it away from the door, allowing hook and loop
fasteners to separate.
(d) Remove nuts and washers from spring return bracket, remove spring return bracket.
(e) Remove roll pin from interior handle shaft.
(f) Remove screws and washers securing span bracket to the door, remove span bracket.
(g) Disconnect the yoke rod ends from the actuation disk by removing each cotter key and
washers from each clevis pin.
(h) Remove roll pin securing main shaft to the actuation disk.
(i) Remove the external handle from the cabin door main shaft.
(j) Remove interior actuator disk.
(4) Installation - Cabin Door Latching Mechanism
Note: Lubricate all moving cabin door latch mechanisms with a dry film lubricant
such as silicone spray.
(a) Install the interior actuator disk.
(b) Install the external handle to the cabin door main shaft.
(c) Secure main shaft to actuation disk with roll pin.
(d) Secure the yoke rod ends to the actuation disk by installing a cotter key and washers to
each clevis pin.
(e) Secure span bracket to door with screws and washers.
(f) Install interior handle shaft roll pin.
(g) Secure spring return bracket with washers and nuts.
(h) Secure the inner door panel with screws.
(i) Secure the interior handle to the interior handle shaft with a screw and washer.