Technical data

13773-001
52-10
Page 930 Nov 2000
(6) Removal - Pin Receiver
The pin receiver has four wear surfaces available. The pin receiver can be rotated to the new
wear surface and then resealed with a white latex caulk.
Note: An alternate pin receiver is available. The alternate pin receiver has the receiver
hole offset to one side. This offset pin receiver can be used if it’s impossible to
latch the door with the standard pin receiver.
(a) Remove the cabin headliner. (Refer to 25-10)
(b) Remove the screw, washer, spring, and washer from the pin receiver.
(c) Push pin receiver out.
(7) Installation - Pin Receiver
(a) Acquire necessary tools, equipment, and supplies.
(b) Solvent clean pin receiver mating surfaces with isopropyl alcohol. (Refer to 20-30)
(c) Apply a thin coat of white latex caulk on the pin receiver mating surfaces.
CAUTION: Never overtighten the pin receiver. Overtightening of the pin receiver may
cause the pin receiver to break.
(d) Place the pin receiver into position and secure with washer, spring, washer, and screw.
Note: If the pin receiver is of the eccentric type, the pin receiver can be rotated to
allow the door skin to fit flush with the fuselage skin.
(e) Install cabin headliner. (Refer to 25-10)
(8) Removal - Door Seals
(a) Remove the seal from the fuselage by pulling them up and away from the fuselage.
(9) Installation - Door Seals
(a) Solvent clean the seal mating area with isopropyl alcohol. (Refer to 20-30)
(b) Starting at the center of the lower door frame, place one end of the seal into position.
(c) Press seal firmly over the door frame making sure that the ends of the seal butt together.
Note: If the door seal doesn’t seal tight against the door, shim the door seal by
applying teflon tape under the door seal in the appropriate area.
(d) After installation, clean door seals with a cloth slightly dampened with isopropyl alcohol.
(10) Cleaning - Cabin Door Seals
It is important that all doors seals are properly secured and cleaned periodically to ensure a
good air-tight and water-tight seal. Clean door seals with isopropyl alcohol.
Description P/N or Spec. Supplier Purpose
Latex Caulk White Dow Corning Seal pin receiver