Technical data

13773-001
71-40
Page 1
ATTACH FITTINGS
1. DESCRIPTION
This section describes those fittings and brackets which are used for support of components in and about
the powerplant. These items include the throttle control cable, governor control cable, mixture control
cable, and fuel and hose line stand-off clamps.
2. MAINTENANCE PRACTICES
A. Throttle Control Cable Bracket (See Figure 71-401)
(1) Removal - Throttle Control Cable Bracket
(a) Remove engine cowling. (Refer to 71-10)
(b) Remove cotter pin, nut, washers, and bolt from throttle control cable at lever arm.
(c) Remove nut, washers, bolt and retaining plate at bracket and remove control cable from
bracket.
(d) Remove nuts and washers securing cable bracket to engine mounting pad and remove
bracket from airplane.
(2) Installation - Throttle Control Cable Bracket
(a) Align control cable bracket with mounting pad studs and install washers and nuts.
(b) Insert control cable into bracket, align retaining plate over cable bracket, and install bolt,
washers, and nut.
(c) Connect control cable to propeller lever arm and install bolt, washers, nut, and cotter pin.
(d) Perform Throttle Cable Adjustment/Test. (Refer to 76-10)
(e) Install Engine Cowling. (Refer to 71-10)
B. Governor Control Cable Bracket (See Figure 71-401)
(1) Removal - Governor Control Cable Bracket
(a) Remove engine cowling. (Refer to 71-10)
(b) Remove cotter pin, nut, washers, and bolt from governor control cable at lever arm.
(c) Remove retaining plate nut, washers, and bolt at bracket and remove control cable from
bracket.
(d) Remove nuts and washers securing cable bracket to engine mounting pad and remove
bracket from airplane.
(2) Installation - Governor Control Cable Bracket
(a) Align control cable bracket with mounting pad studs and install washers and nuts.
(b) Insert control cable into bracket, align retaining plate over cable bracket, and install bolt,
washers, and nut.
(c) Connect control cable to governor control lever arm and install bolt, washers, nut, and cot-
ter pin.
(d) Perform Governor Cable Adjustment/Test. (Refer to 61-20)
(e) Install Engine Cowling. (Refer to 71-10)
C. Mixture Control Cable Bracket (See Figure 71-401)
(1) Removal - Mixture Control Cable Bracket
(a) Remove engine cowling. (Refer to 71-10)
(b) Remove cotter pin, nut, washers, and bolt from mixture control cable at lever arm.
(c) Remove retaining plate nut, washers, and bolt at bracket and remove control cable from
bracket.
30 Nov 2000