Technical data

13773-001
76-10
Page 1
POWER CONTROL
1. DESCRIPTION
This section describes those components which furnish a means of controlling engine power. Engine con-
trols for the airplane include the following: control quadrant, throttle control cable, mixture control cable,
and governor control cable.
2. MAINTENANCE PRACTICES
A. Control Quadrant (See Figure 76-101)
(1) Removal - Control Quadrant
(a) Remove RH cockpit seat. (Refer to 25-10)
(b) Remove control-quadrant friction knob and washer.
(c) Remove RH and LH aft console trim panel. (Refer to 25-10)
(d) Remove throttle control cable mounted to control quadrant. (Refer to 76-10)
(e) Remove mixture control cable mounted to control quadrant. (Refer to 76-10)
(f) Remove governor control cable mounted to control quadrant. (Refer to 76-10)
(g) Remove nuts, washers, and bolts securing control quadrant to center console framework.
(h) Remove control quadrant from airplane.
(2) Installation - Control Quadrant
(a) Position control quadrant on center console framework and install bolts, washers, and
nuts.
(b) Install throttle control cable mounted to control quadrant. (Refer to 76-10)
(c) Install mixture control cable mounted to control quadrant. (Refer to 76-10)
(d) Install governor control cable mounted to control quadrant. (Refer to 76-10)
(e) Perform Governor Low-Pitch Stop Adjustment/Test. (Refer to 61-20)
(f) Perform Throttle Control Adjustment/Test. (Refer to 76-10)
(g) Perform Mixture Control Adjustment/Test. (Refer to 76-10)
(h) Install RH and LH aft console trim panel. (Refer to 25-10)
(i) Install control-quadrant friction knob.
(j) Install RH cockpit seat. (Refer to 25-10)
31 July 2001